Mounting OS6855-14/P14 and OS6855-U10 Switches Industrial Environment Mounting Options
OmniSwitch 6855 Series Hardware Users Guide September 2011 page 4-31
DIN Rail Mounting - PS-I40AC System Power Supply
1 The PS-I40AC power supply requires a user installed DIN bracket. To install the power supply, use the
three (3) attachment screws to secure the bracket to the power supply as shown in the diagram below.
Attaching DIN Rail Racket to PS-I40AC Power Supply
2 The DIN bracket has a spring-loaded clip under the bottom flange. This clip helps hold the bracket
securely to the rail. Hook the bottom flange under the DIN rail and press up slightly. While applying slight
upward pressure, press the DIN bracket against the rail until it clicks into place.
DIN Rail Mounting PS-I40AC Power Supply
Spring-Loaded DIN Rail Bracket
To Next Page
Loading...
