1
CAUTION!
This manual is intended for use by trained technicians only, having full understanding of electric
vehicles and their unique installation requirements.
The ALCOLOCK V3 device can be installed in all 12V & 24V vehicles.
NOTE: Open vehicles excluded.
KIT / TOOLS NEEDED
• V3 ECU (12 volt 79-008811) or (24 volt 79-008847)
• V3 handset (79-009000)
• Handset clip xture (58-000257)
• ECU to interlock handset cable (13-001050)
• ECU wiring harness (13-001120)
• Installation kit (hook and loop tape, tie wraps, hardware, heat shrink tubing, terminal ring /
crimp / nut) (95-000514)
• Round mouthpieces (bag of 25) (95-000250)
Also: wire strippers, soldering iron, heat gun, multimeter, screwdriver.
To order replacement parts, consult the preceding list.
INSPECTION
Before the ALCOLOCK V3 device is installed, an inspection of the vehicle’s electrical system is
required.
Check:
• Battery voltage
• Charging system
• Starting system
To Next Page
Loading...
