6. Rotate the D handle (12) 180 degrees back to its
original position, and using the supplied 4mm
hex key (26), tighten each of the 4 bolts until
they are secure. (Fig K)
Fitting of the Spool and Line Assembly
NOTE: Always ensure the engine is turned off
before undertaking this assembly.
1. Rest the line trimmer on the ground or a secure
surface such that it is resting on the fuel tank (6).
Place the spool and line assembly (21) over the spindle locating the
hexagonal recess on the spool and line over the hexagonal drive on the top
of the spindle. (Fig L)
NOTE: When the spool and line is in the correct
position, the spindle will protrude from the
opposite side. (Fig M)
3. Place the bump knob on the spool and line
assembly (21), and screw the bump knob (20) into
the spindle finger tight. (Fig N)
4. Using the supplied spool tool (25), insert the raised
tabs on the spool tool (25) into the notches on the
bump knob, and further tighten until secure, whilst
holding the spool and line assembly (21) with the other hand. (Fig O)
IMPORTANT: After the spool and line assembly (21) has been fitted to the
shaft and the bump knob (20) secures, both lines must be pulled firmly to
ensure the line is free from the internal notches, and also the inner spool
is unlocked from the spool cover. The inner spool should be sitting on the
bottom of the bump knob (20) under spring pressure. No gap should exist
between the bump knob (20) and the inner spool.
K.
L.
N.M. O.
TIGHTEN
LOOSEN
General Assembly
To Next Page
Loading...
