Mixing the fuel
MOTOR FUEL: MIX AT 40:1 ONLY
For example: For 1 litre of unleaded petrol add 40ml of oil.
For 5 Litres of unleaded petrol add 125ml of oil.
IMPORTANT. Use good quality air cooled 2-stroke engine oil. This product is
powered by a 2-stroke engine and requires pre-mixing fuel with 2-stroke oil.
1. Use fresh unleaded fuel. Do not use ethanol based fuels . You must use
2-stroke oil specifically made for heavily stressed two-stroke engines.
2. Mix the fuel and oil in an approved container. Never mix fuel and oil directly
in the line trimmer fuel tank (6). Use the supplied fuel mixing container (22)
included with this product. (Fig AB)
3. Using the supplied fuel mixing container (22), fill to the 1:40 mark, then fill
with oil to the 600ml marking. (Fig AC)
WARNING. Never use any type of pre-mixed fuel/oil from fuel
stations as these may include special blends solely intended for use
in mopeds. motorcycles, etc.
3. Mix the fuel and oil thoroughly and also each
time before fuelling.
4. Always pre-mix in small quantities. Never mix
quantities larger than what will be used in a
30-day period.
NOTE: The fuel mixing container (22)
provided is NOT for the storage of fuel.
This container is solely for mixing of
fuel and oil only.
Ensure to keep this container in a safe
storage location, empty of fuel and
out of reach of children.
AB.
AC.
2 STROKE OIL
FUEL
To Next Page
Loading...
