AFTER SALES SUPPORT
1 866 558 8096
service@eurocentra.net
5
PEDAL EXERCISER ASSEMBL
Y
Step 1: Install Battery
To install the battery, you must take
the Digital Display (2) out of the
pedal exerciser. Remove plastic
from the provided battery (11)
before inserting into the battery
compartment. Gently place the
Digital Display (2), with the sensor
bar loose, into the pedal exerciser.
Step 2: Install Support Bars
Secure the support bars (3) with
the washers (8) and the screws (7)
to the base of the pedal exerciser.
See figure.
Step 3: Install Pedals
Using the supplied wrench (9),
screw the left pedal (6) counter-
clockwise into the left crank arm
of the pedal exerciser. An “L” is
etched on the end of the pedal
indicating the left side pedal. Using
the supplied wrench (9), screw
the right pedal (4) clockwise into
the right crank arm of the pedal
exerciser. An “R” is etched on the
end of the pedal indicating the right
side pedal.
Double check that all bolts, nuts and screws
are securely tightened before use.
To Next Page
Loading...