39
Operation
• Always use the parallel stop when making angular cuts.
• Use a push stick or push block to feed the workpiece past the
saw blade. If the push stick is damaged or worn, replace it
immediately.
• Secure long workpieces against falling off at the end of the cut.
• To do so, use e.g. standard roller stands, etc.
• After every new adjustment, make a trial cut in order to check the
set dimensions.
• After switching on the table saw, wait for the blade to reach its
maximum speed of rotation before commencing with the cut.
• Take extra care when starting the cut!
• Only use the table saw together with a vacuum extraction device.
• Regularly check and clean the suction channels.
Making longitudinal cuts
When you make a longitudinal cut, you cut the workpiece in its
longitudinal direction. To do so, press one edge of the workpiece
against the parallel stop (
20
) while the flat side lies on the saw
table (
1
).
1. Set the parallel stop in accordance with the workpiece height and
the desired width (see the section “Parallel stop”).
2. Lower the saw blade guard (
2
) down to the saw table.
When sawing, the saw blade guard will be pressed up by the
workpiece.
3. Switch on an extraction system and then the table saw.
4. Place your hands (with fingers closed) flat on the workpiece and
push the workpiece along the parallel stop and into the saw
blade (
31
).
5. Provide guidance at the side with your left or right hand
(depending on the position of the parallel stop) only as far as the
front edge of the saw blade guard.
Layout_F_TS_2000_1_UK_SPK7.indd 39Layout_F_TS_2000_1_UK_SPK7.indd 39 23.06.2020 14:29:3723.06.2020 14:29:37
To Next Page
Loading...
