Removing a jammed laminating pouch
The laminator is equipped with an antiblocking system. If the laminating pouch was
not inserted straight or it becomes jammed in the laminator, proceed as follows:
1. Move the ABS switch
4
towards the laminating pouch infeed slot
2
and hold
it down (see fig. B).
2. Pull the laminating pouch
6
out of the laminator.
It is recommended you pull the laminating pouch out in the direction
of its larger end.
You can place the document in a new laminating pouch and laminate it again.
Cleaning
WARNING!
Burn hazard!
The laminator will become hot during operation. You may burn
yourself.
− Always let the laminator cool off completely before you clean it.
NOTICE!
Risk of short circuit!
Water that has penetrated the housing may cause a short circuit.
− Never submerge the laminator in water.
− Make sure that no water penetrates the housing.
NOTICE!
Risk of damage!
Improper handling of the laminator may result in damage to the
laminator.
− Do not use any aggressive cleaners, brushes with metal or
nylon bristles, sharp or metallic cleaning utensils such as
To Next Page
Loading...
