34
Alarm function
You can set two different alarm times with the base station.
1. Select the required alarm time by pressing the MODE/SET. button (A1 or A2).
2. Keep the MODE/SET. pressed for approx. 2 seconds, when you have selected the
required alarm time.
The hour display of the alarm time (A1 or A2) flashes.
3. Using the +/ or -/ /ZONE buttons, set the required alarm hour.
4. Press the MODE/SET. button to save the setting.
The minute flashes in the display.
5. Using the +/ or -/ /ZONE buttons, set the required alarm minute.
6. Press the MODE/SET. button to save the setting.
The alarm time is set and activated.
Switch alarm function on and off
The alarm function is switched on an off using the +/ button.
z Press 1x: A1 is active is displayed
UK Funkwetterstation.book Seite 34 Freitag, 13. Juni 2014 1:47 13
To Next Page
Loading...