52
After approx. 20 seconds, the display begins to flash and the data from the radio
sensors is queried.
2. Pay attention to the displayed values.
3. If incorrect values continue to be displayed: Remove the batteries from the radio
sensors used and reinsert them.
4. Proceed as described from page 18 .
In order to accelerate the data interchange between the weather station and
radio sensor, you can keep CHANNEL pressed on the weather station until the
display flashes and press the TX button on the appropriate radio sensor. With
this, the weather data will be directly transmitted to the base station.
Have time displayed in a different time zone
The requirement for this is that you have also entered the time in a second time zone,
see from page 24.
1. Press the -/ /ZONE button if you intend to have the time in a second time zone
displayed. Next to the time, ZONE is displayed.
2. Press -/ /ZONE again, if the originally displayed time should appear again.
UK Funkwetterstation.book Seite 52 Freitag, 13. Juni 2014 1:47 13
To Next Page
Loading...