55
The weather station does not
receive any sensor signals.
- Ensure that no electrical disruption sources
are near the sensor or the base station.
- Check the batteries in the sensor.
- Start the radio reception manually: Keep the
CHANNEL button pressed on the base station
until the display for weather data OUT flashes.
You can also keep the TX button pressed in
the battery compartment of the radio sensor
in order to transfer the data to the base sta-
tion more quickly.
- Move the weather station closer to the sensor
or vice versa.
The display is illegible, the func-
tion is unclear or the values are
obviously incorrect.
- Reset the weather station to its original fac-
tory settings, see page 51.
In the display, HH / LL is shown in
the display instead of the meas-
ured values for temperature/
humidity.
- The values are above/below the measure-
ment range, see "Technical data".
UK Funkwetterstation.book Seite 55 Freitag, 13. Juni 2014 1:47 13
To Next Page
Loading...