To Next PageTo Next Page
Need help?Do you have a question about the Aleko Victoria Series and is the answer not in the manual?
General| Brand | Aleko |
|---|---|
| Model | Victoria Series |
| Category | Accessories |
| Language | English |
Assembling the roller connector with left and right rollers.
Assembling the front bar connector with left and right front bars.
Assembling the torsion bar connector with left and right torsion bars.
Combining roller support, gear box, and shaft cover for the roller.
Assembling arm shoulder with bolts and adjustable bolt.
Linking torsion bar and arm shoulder, tightening securely.
Linking left and right arms with corresponding arm shoulders.
Spreading fabric and valance, inserting liner into gauges.
Attaching blocker, arm-bar link, and plastic covers to the front bar.
Hammering roller support with gear box into the torsion bar.
Inserting square shaft into roller and gear box, linking round shaft.
Aligning components, tightening bolts and nuts for proper awning positioning.
Addresses fabric wrapping unevenly or arms not opening together.
Do not install in windy/high places, avoid vibrations, high temperatures, heavy objects.
Measure wall distance and drill holes for wall brackets based on expansion bolt size.
Hammer expansion bolts into holes and reattach nuts and washers.
Fix wall brackets using expansion bolts, leaving slight movement for adjustment.
Specifies wall bracket spacing based on awning size for proper support.
Angling the awning surface to about 80 degrees with the wall when open.
Install the awning onto the wall brackets and tighten all bolts securely.
Information on alternative mounting options for ceiling or wall brackets.
Emphasizes proper bracket location and secure fastening to structural components.
Instructions on adjusting pitch using locking nuts and jack bolt for leveling.
Illustrates correct and incorrect awning operation, warning about front bar touching roller.
Shows the physical installation of the motor unit onto the awning.
Illustrates the electrical connections for the motor and switch.
Combining the motor bracket with the roller support using bolts.
Connecting the motor down-lead and power supply to the switch correctly.
Using a screwdriver to adjust motor opening distance via regulation holes.
Notes on hand crank, thermal protection, operating temperature, and closing in wind.
