Alen HEPA - Using Your Air Purifier; Operating Your Unit

5
www.AlenCorp.com 1-800-630-2396
USING YOUR AIR PURIFIER
Operating Your Unit:
1. Plug your air purier into a grounded outlet.
2. Press Power Button in the center to start the air purier. When your unit is on, the
lights will light up. To turn off the lights on your unit, press the Power Button. To turn
off the air purier, press the Power Button again after the lights have turned off.
3. The Colored Light around the Power Button indicates the air quality being measured
by the particle sensor.
4. Press ION to activate the ozone safe ionizer. Activation of ION enhances your unit’s ability
to remove airborne particles (similar to the way dust is attracted to a TV screen). Press
ION again to turn off.
5. FILTER LIFE Indicator — The Filter Life indicator has 3 lights: Green, Yellow and Red.
The Green light will be illuminated for most of the life of the lter. The Yellow light will
come on shortly before your lter should be replaced. This is the ideal time to order a new
lter. The Red light will be illuminated when it is time to replace the lter.
6. After changing the lter, hold the FILTER LIFE button down for 5 seconds. The Red light
will be reset to Green.
7. Press TIMER to have the air purier run for a set amount of hours (either 4, 8 or 12)
before turning off.
8. Press SPEED and watch the indicator lights until desired fan speed is achieved. Most
users prefer to use the air purier on speed 2 or 3 to balance cleaning speed and noise. If
you suspect the air is particularly dirty, you should set the speed to T (Turbo).
9. Press AUTO to set the unit on Automatic Mode. Automatic Mode will use the SmartSen-
sor Technology to adjust the speed of the unit depending on the amount of particles
present in the air.
Color Meaning
Blue Low quantity of airborne particles detected
Yellow Moderate quantity of airborne particles detected
Red Signicant quantity of airborne particles detected