Alen HEPA - Know Your Air Purifier; Features; Care & Maintenance

7
www.AlenCorp.com 1-800-630-2396

When using the air purier for the rst time in a room, we recommend that you use a higher fan
speed like speed three (3) or Turbo (T), for at least two hours in order to clean the room’s air
initially. Then, we recommend that the air purier run continuously on speed two (2) or three (3)
or be set on automatic mode.
Features
• HEPA type ltration captures dust, allergens and airborne pollutants
• Ionizer charges smaller particles, causing them to clump together for improved ltration
• 4 fan speeds with a 4, 8, & 12 hour timer to control air circulation
• Automatic mode sets speed for optimal performance
• Filter change indicator light keeps replacements on schedule
• Simple and intuitive touch button controls
• Auto-off safety feature when front cover is removed
• Filter designed for easy replacement
CARE & MAINTENANCE

To turn the lights off on your unit, press the Power Button. The lights will go out but the unit
will not turn off. Press any button to turn the lights back on, or press the Power Button a 2nd
time to turn the unit off completely.
Replacing The Filter
The Filter Life Indicator has 3 lights: Green, Yellow and Red. The Green light will be illuminated
for most of the life of the lter. Yellow light will come on shortly before your lter should be
replaced. This is the ideal time to order a new lter. You may order a new lter at www.alencorp.
com/lters or by calling 1-800-630-2396. The Red light will be illuminated when it is time to
replace the lter.
The lters used in Alen HEPA Air Puriers are not designed to be washed, cleaned or otherwise
reused. Over time, the lters become overloaded with particles, decreasing their ltration per-
formance. We recommend regular lter replacements to extend the life of your air purier and
maximize performance.
The black foam layer of the lter, known as the Pre-Filter, captures large dust and hair. This
layer is held on with Velcro
®
. Once removed, the Alen Pre-Filter can be washed or vacuumed to
maintain efcient operation of the unit.

After replacing the lter, hold the FILTER LIFE button down for 5 seconds. The Red light will be
reset to Green.