Autolocation and Loop Functions - Chapter 5
44 ADAT LX20 Reference Manual
LOOP LIMIT
To protect against unnecessary wear and tear, the LX20 automatically disables
Auto Loop after completing 100 consecutive loops. To disable this safeguard, hold
the SET LOCATE button and press AUTO RETURN. Pressing STOP restores the 100
loop limit.
Alesis strongly recommends leaving loop limit enabled.
While the LX20 is Auto Looping, you can check how many loops have elapsed by
holding SET LOCATE and pressing AUTO PLAY.
DEFERRED PLAY AND RECORD
To automatically enter play mode after locating, press PLAY before a locate
completes. To cancel deferred play while the tape is moving, press STOP,
REWIND, FFWD, or a LOCATE POINT button.
To automatically enter Record mode after locating, press PLAY and RECORD before
a locate completes. To cancel deferred recording while the tape is moving, press
PLAY, STOP, REWIND, FFWD, or a LOCATE POINT button.
To Next Page
Loading...
Need help?
General
