3
Chapter 3: Fusion Modes
124
Menu: Song/Track/General
Parameter: Arp Number (not available for audio tracks)
Value Range: None, 1-4
Each song can have up to four arpeggiation patterns. Select the
arpeggiation pattern you’d like to use for this track. If you do not want
to use an arpeggiation pattern for this track, set this parameter to
“None.”
Menu: Song/Track/General
Parameter: MIDI Channel (not available for audio tracks)
Value Range: Global Channel, 1-16
This parameter sets the MIDI channel on which the current track will
transmit and respond to MIDI data.
Menu: Song/Track/General
Parameter: Enable Loop
Value Range: On, Off
This parameter lets you enable or disable looping a particular segment of
the song. The segment is determined by the “Loop Start” and “Loop
End” parameters (See below). Check this box if you want looping to
take place, and leave the box unchecked if you want the song to play
through normally. Tracks will loop until the end of the song is reached.
Menu: Song/Track/General
Parameter: Loop Start
Value Range: (Varies depending on loop length)
This parameter determines where the looping will begin in your song.
Menu: Song/Track/General
Parameter: Loop End
Value Range: (Varies depending on loop length)
This parameter sets the end point of the loop in your song. When you
are playing a song and you reach this point, the song will jump back to
the “Loop Start” point (see above) and replay the looped portion of the
song until you press the “Stop” button on the transport or until the end
of the song is reached.
To Next Page
Loading...
Need help?
General
