8
To save the global parameters set in the Options menu:
1. Press and hold the Cursor Down and Cursor Right buttons
for 2 seconds to enter the main Save menu.
2. Press the Cursor Up and Cursor Down buttons to highlight
SAVE GLOBAL SETTINGS,
3. Press Cursor Right to enter the SAVE GLOBAL SETTINGS
submenu.
4. Press the Cursor Up and Cursor Down buttons to highlight
YES and press Cursor Right to save the global settings.
5. To exit the SAVE GLOBAL SETTINGS submenu, press the Cursor Down until Exit is highlighted, and then
press the Cursor Right button. Alternatively, press and hold the Cursor Down and Cursor Right buttons to
exit this menu.
Metronome
• Switch: Turns the metronome on or off.
• Sound: Selects the sound of the metronome from Voice,
Metronome, Claves, Sticks, Cowbell, and Beep.
• Tempo: Adjusts the tempo of the metronome from 30-280
BPM (Beats per Minute).
• Level: Adjusts the volume of the metronome from 0-10.
• Time: Adjusts the time signature for the metronome. The available time signatures to select from are 1/2, 1/4,
1/8, 1/16, 2/2, 2/4, 2/8, 2/16, 3/2, 3/4, 3/8, 3/16, 4/2, 4/4, 4/8, 4/16, 5/2, 5/4, 5/8, 5/16, 6/2, 6/4, 6/8, 6/16, 7/2,
7/4, 7/8, 7/16, 8/2, 8/4, 8/8, 8/16, 9/2, 9/4, 9/8, and 9/16.
Footswitch
The footswitch input of SamplePad Pro supports both standard 1/4" TS
single-button and 1/4" TRS dual-button footswitches.
For 1/4" TS single-button footswitches, you can only assign one
function to the single button by changing the setting for
FOOTSWITCH1.
For 1/4" TRS dual-button footswitches, you can assign functions to both buttons by changing the settings for
FOOTSWITCH1 and FOOTSWITCH2. You can also assign a function to happen when you press both buttons of the
footswitch at the same time by changing the setting for SIMULTANEOUS.
The available footswitch functions are:
• Click: Starts/stops the metronome
• Stop All: Mutes all currently playing samples
• Next Kit: Selects the next kit
• Prev Kit: Selects the previous kit
• Tempo: Press the footswitch several times to set the tempo of the metronome
Hi-Hat
• Position Settings: This submenu allows you to adjust the hi-hat
pedal ranges for the "HAT OPE", "HAT MID", and "HAT CLO"
trigger locations of SamplePad Pro.
To Next Page
Loading...
Need help?
General
