-7-
ELECTRIC SLIDING DOOR - TROUBLESHOOTING
O
R
I
G
I
N
A
L
01.20
ESDT 0001
REMOTE CONTROL AND BUTTONS
* Key fob openes only when engine switch is on.
* Remote control key and door handle operates only when ignition key is on.
* Door can be closed once while egnition switch is o.
* Continuss press on driver’s switch allows door to operates even if there is an obsticle
BEEPING SOUNDS
Learning Mode: Fragmented beeping will be heard when door is at its rst learning cycle.
Opening Mode: Fragmented beeping will be heard when door is opening.
Closing Mode: Fragmented beeping will be heard when door is closing.
Obstacle Detection On Closing Mode: Continuous beeping will be heard.
If the sliding door is obstructed during the closing procedure, it opens fully again(for 2 attempts).
On third attempt the electric sliding door moves with increased force.
Remote control doesn't operate
Remote control operates only when ignition key is o.
Check remote control's batteries. Replace if needed.
Verify that the remote is programmed To the electric control box and reprogram if needed.
Check if central locking signal wire is connected to electronic control box pin 4 plug 3.
For vehicles with original remote control (as Sprinter / Crafter / Transit / Ducato, etc)
Door handle operation Door handle operates only when ignition key is on.
Micro switch installed in door should not be pressed when the door handle isn’t pulled.
Check micro switch remote control's batteries, replace if needed.
Reprogram door handle remote control to electronic control box.
Dash button doesn't operate
Driver button operates only when ignition key is on.
Check connections after ignition.
Check if the Blue LED in the driver button is on when the door is closed and ashing when the door is open.
While pressing dash button Check output single on the button white wire to electronic control box.
Door does not work at all from dash switch and the remote control
Check fuse of the door system.
Check the battery voltage on the electronic control box main supply plug.
Opening Door while vehicle is on downhill position and door is slowing down slowly
Check if there is an electrical brake when the door Is fully open. if not switch remote control's batteries, replace
if needed.
If not, reprogram door's system door handle remote control to electronic control box.
VSS signal = door is not closing automatically when the vehicle starts moving on the road
Check if the VSS signal option is connected correctly to the original cantus / wires of the vehicle.
if there is no connection to the original speed of the vehicle, please use ALEX ORIGINAL VSS print P.N. 1740-001.
Others
Check the belt for damage.
Check the belt’s length.
If needed, readjust the belt for 6-7 teeth (as per installation manual).
CONTACT
(Phone) +972-9-8855441
(Fax) +972-9-8855442
ONLINE
(E-mail) info@alex-original.com
(Web) www.alex-original.com
ADDRESS
ALEX ORIGINAL
16 Hamelacha St., P.O.BOX 8521,
Netanya. 4250551 Israel
To Previous Page
Loading...