Operating Manual
IF THERE ARE ANY PUMPING PROBLEMS
REFER TO THE FAULT FINDING CHART
ALL ANSWERS SHOULD BE YES BEFORE PROCEEDING
5.0 Start Up, Shut Down and Cleaning
5.1 Pump Start Up Check List
1. Is the location of the 'stop' button clear?
2. Has the pipework system been flushed
through to purge welding slag and any
other hard solids.
3. Have all the obstructions been removed
from the pipework or pump?
4. Are the pump connections and pipework
joints tight and leak-free?
5. Are the pipework valves open?
6. Are all safety guards in place?
7. Start then stop the pump, is the product
flowing in the correct direction?
8. Are the pump speed/pressure settings
below the pump maximum limitations?
YES NO
12
To Next Page
Loading...
Need help?
General
