Align 3GX Compact - Page 8

STEP1.4 : COLLECTIVE PITCH SETUP
RANA : ENIRE (BABES AE
Adjust the maximum collective pitch using the transmitter's swash
plate mixing function (pitch swash AFR). Recommended pitch range
+42, maximum pitch range for advanced pilot shall not exceed #14 .
AIEEE +12 : SRPRSRBB+14 AR-
+12 Collective pitch
Do not adjust individual servos endpoints through the servo
ATV/AFR function, use only swashplate mixing adjustments.
Should any changes made to the endpoints or trims on the
transmitter in the future, the flybarless system initial setup must
be performed again.
CCPMARBE TSB + AiR Swasht+ FRR (Pitch
swash
AFR)
H
:
DABBOSGARSOVATVTIER
>
BRELSOANBUARS > WAS MET FlybarlessS ARE -
While using 3GX FBL system, be sure to turn off the
following functions in the transmitter
{EFSGXAME RERNA FSAI DE
%*
Swash
Ring
*
Linkage
Compensation
*
Swash
Mix
*
Mixing
*
Acceleration
Example : cyclic pitch of 8: STEP1.5 : CYCLIC PITCH SETUP
Futaba 12ZH with three BL 700H's BRAS : IRR
AlLeron swash AFR : 53% (8°) Swashplate: lic pitch setting: With the main blades parallel to
Elevator swash AFI 3% helicopter ly, throttle stick positioned where main pitch is
Pitch swash AFR : 37% (+12°) 0 degrees, move aileron stick all the way to the right, adjust the
3 3 AIL mixing ratio within radio's SWASH menu so the main blade
APG
ROR
PE
89
TES"
AP
+
pitch
is
the
factory
recommended
value
+8
degrees.
The
ELE
Fataba 12ZH 7880 BL 700H x3 mixing ratio in SWASH menu can be set to the same value as AIL.
N + SRR ERROREA BPIEPERENRARO
Pitch h AFR : 37% (412° MUBHAM + HIRE EITAESwash PAILLE » EENE
SHS Mas AER SLR EI2y) PTE ARATE +O 18 1T2Evash ELELEE AAAIL LLARABIBN] ©
If adjustments is needed for aileron and elevator roll rate, it can
lone through 3GX interface's flight mode settings, or through
> Eh 3GX PC interface.
48° Cyclic pitch -z SRHLGRRAMRRGRKG THICKMMMAICXAMTHE IVE MUI
d
SGX
RS
TIE
<
Adjustments to the CCPM servos endpoints should be done
through transmitter's swashplate mixing function (AIL swash AFR).
Do not adjust individual servos endpoints through the servo
ATV/AFR function. Should any changes made to the endpoints or
subtrims on the transmitter in the future, the flybarless system
initial setup must be performed again.
CCPM ARAB TS MOS + HEP SESWash+ FM RIT BHI >
DEBS BOMRBVATV TER > MRELSAMAUARS » Wh
ABUETFlybaressS ARE
2.E.LIM SWASHPLATE MIXING TYPE RECOGNITION STEP2.1 : ENTERING E.LIM SETUP MODE
AND
ELEVATOR:
ENDPOINT:
SETUP
-
Anie
keeping
swashplate
level
and
main
pitch
at
zero
degrees,
E.LIM-+ FNRA Ht Bie Ae iT FS MBAS EAT : press the SET button to register the neutral point and enter E.LIM
setup mode. The E.LIM LED will lit up after DIR turns off.
RG+FRAKE ` RRUBLABLAKEK + BIZ P'SET' MOIR IE
Si
ELIM
BERE
>
EA"
ELIMARACTIZR
"ERT
©
The throttle stick position where main pitch is 0 degree must
be maintained through this setup process.
OPESAEGKTRR ASSOLE : TIBB -
E.LIM settings
ELIMI?
Seo)
ia
GE hey