Vesta H2, Athena H2, Melody II
Manual Addendum
While AutoAdjust automatically provides very fine real-time adjustments to the pulse width, you can also manually
adjust the power to best suit your unique water quality and desired performance requirements. By manually changing
the power-steps for each Alkaline and Acidic level, you can change the main power settings, making bigger and more
impactful changes in performance. There are 4 Power Levels (1 – 4). Power Level 1 is the lowest and Power Level
4 the highest. Follow this procedure to adjust the Power Levels:
1. Start with unit plugged in, water flow turned off..
2. Simultaneously press and hold the Alkaline 1 and Alkaline 2 buttons for 3—5 seconds, until the screen
looks like Fig. 1.
Fig. 1
3. Press and release the Alkaline 2 button 6 times. The display should now look like Fig. 2
Fig. 2
4. Each time the Acidic 1 button is pressed, the display will cycle through the alkaline and acidic levels,
first in Forward polarity and then in Reverse polarity. (refer to Fig. 3a, 3b, and chart 3c)
© AlkaViva, LLC 4/4/2017
Recommended Method for Manually Adjusting
Power Settings
To Next Page
