12 13
Turn on power to fan.
Within 30 sec, press and hold
“LEARN” button for 3 sec.
Once receiver has detected
the frequency, transmitter with
“Beep Beep” twice.
Programming process is
completed and fan is ready
to use.
The receiver & transmitter is pre-programmed in factory. If you wish to control 2 or
more fans using 1 transmitter, the below steps are required.
DO NOT PRESS ANY OTHER BUTTON DURING THIS PROCESS
Transmitter
Learning Process
Press and hold
for 3 sec
Learn
Transmitter
AAA
AAA
10
11
10
To Next Page
Loading...