1716 1716
When the cooking process is complete, the appliance will automatically activate the keep warm function.
The WELL DONE indicator light will remain lit, and the appliance will beep every 20 seconds.
If the food is left in the grill, it will continue to cook while the plates cool down. You can press "OK" to
stop the beeping.
NOTE: the safety system will automatically turn off the appliance after a certain period of time (approximately
30 minutes).
• Press on/off to turn off the appliance.
• Unplug the grill.
• Allow to cool for at least 2 hours.
• To avoid accidental burns, allow the grill to cool completely before cleaning.
• Before cleaning, unlatch and remove the plates to avoid damaging the cooking surface.
• The drip tray and the cooking plates are dishwasher safe.
• The appliance and its cord must never be placed in the dishwasher. The heating elements (the visible
and accessible parts) must never be cleaned after the plates have been removed. If they are very dirty,
wait until the appliance is completely cool and use a dry cloth to clean them.
If you do not want to place the plates in the dishwasher, use hot water and a little dish detergent to
wash them, then rinse them thoroughly to remove all residue.
• Wipe them carefully with a paper towel.
• Do not use a metallic scrubber, steel wool or abrasive cleaning products to clean any part of the grill.
Only use nylon or non-metallic cleaning pads.
• Empty the drip tray and wash it in slightly soapy hot water, then wipe it with a paper towel.
KEEP WARM FUNCTION
CLEANING AND MAINTENANCE
• To clean the lid of the grill, wipe it with a sponge rinsed in hot water and then dry it with a soft, dry cloth.
• Do not immerse the casing of the grill in water or any other liquid.
• Ensure that the grill is clean and dry before storage.
• Any repairs must be carried out by an approved service representative.
FAQ
Problems Cause Solutions
button flashing
+ solid
indicator light +
button flashing.
Switching "ON" of the
appliance or starting an
automatic cooking cycle
with food between plates
and without preheating
(setting temperature). The
manual mode is
automatically activated.
2 possible options:- choose the temperature setting
by pressing the button and then press .
Allow to cook, but you must monitor the cooking
(manual mode). Open the grill completely, remove
the food, close the grill properly, re-program the
grill and wait until the end of preheating (setting
temperature).
The grill stops during
the cycle of
preheating (setting
temperature) or
cooking.
The grill has been kept
open for too long while
cooking. The grill has been
idle too long after the end
of warm up (setting
temperature) or keep warm.
Disconnect the grill from the outlet and leave for
2-3 mins, restart the process. The next time you
use the grill, make sure you open and close it
quickly for the best cooking results. If the problem
occurs again contact your local All-Clad customer
service.
To Next Page
Loading...
