The DT168 is a portable, rugged Dante I/O unit. It can be used to complement
Allen & Heath digital mixing systems on a Dante network. It provides 16 remote
controlled mic/line preamps and 8 XLR line outputs. It connects to the Dante
network over a single Cat5e cable, or two cables for redundancy.
The DT168 can be operated horizontally with the connectors facing upward or
sideward, or vertically to save space on stage. It can also be mounted in a 19”
rack or flight case using the optional AB1608-RK19 kit. A hard-wearing padded
polyester carry case is also available, A&H part number AP9932.
Software and firmware
Visit the Audinate website to learn more about Dante, and download Dante
Controller to route audio and configure devices on a Dante network:
https://www.audinate.com/
Preamp control of the DT168 by an SQ mixer requires SQ
firmware V1.4 or higher and SQ Dante card firmware V1.0.5+.
Preamp control of the DT168 by a dLive mixer requires dLive
firmware V1.8 or higher and a dLive M-DL-Dante 64x64 or 128x128
card. Use of the iLive/GLD M-Dante card is not supported.
Check www.allen-heath.com for the latest DT168 firmware and
instructions on how to update it.
Front panel
To Next Page
Need help?
General
