Index
I–2
Publication 1336 IMPACT-6.2 – March 1998
Ridethru Time, 2–11
SP 1 Timeout, 2–8
SP 2 Timeout, 2–9
SP 3 Timeout, 2–9
SP 4 Timeout, 2–9
SP 5 Timeout, 2–9
SP 6 Timeout, 2–9
SP Error, 2–9
Spd Fdbk Loss, 2–8
SW Malfunction, 2–6
Viewing Queue with HIM, 2–3
Feedback Loss Fault, 2–18
Four-Point Mounting, 3–3
G
Gate Driver Board
Illustration, 3–15
Installation, 3–16
Removal, 3–15
Test, 4–12
GPT. See Graphic Programming Terminal
Graphic Programming Terminal
Description, 1–12
Illustration, 1–13
Ground Sense CT
Illustration, 5–4
Installation, 5–6
Removal, 5–4
H
HIM. See Human Interface Module
Human Interface Module
Adapter Locations, 1–10
Description, 1–9
Illustration, 1–9
Operation, 1–12
Human Interface Module (HIM), Viewing
Fault/Warning Queues, 2–3
I
Input Mode. See L Option Mode
Input Rectifier
Illustration, 5–13
Installation, 5–14
Removal, 5–13
Test, 4–3
Inputs, Available, 1–4
J
Jumper, Definition, P–11
L
L Option, 1–2
Inputs, 1–4
Options, 1–2
L Option Board
Definition, P–11
Illustration, 3–7
Installation, 3–8
Jumper Locations, 1–3
Removal, 3–8
L Option Mode, 1–4
Programming, 1–4
Selection, 1–5
Three-Wire, Multi-Source, 1–6
Three-Wire Control, Multi-Source
Reversing, 1–7
Two-Wire, Single-Source, 1–6
Two-Wire Control, Single-Source Control,
1–7
Load-Sharing Resistor Connections, 5–23
Local Programming, 1–5
M
Main Control Board
Illustration, 3–11
Installation, 3–12
Removal, 3–11
Main Control Board Mounting Plate
Illustration, 3–9
Installation, 3–10
Removal, 3–9
Major Component Replacement. See
Procedures
Manual
Audience, P–1
Conventions, P–10
Objective, P–1
Related Publications, P–12
Mounting
Four-Point, 3–3
Two-Point, 3–3