Publication 1747-UM655B-EN-P - June 2007
Communicating with the DeviceNet Network from Another Network 75
6. Expand your DH+ driver (AB_KT-1 above) and select the SLC
500 processor.
7. Verify that the 1747-SDN Slot is correct.
8. Click OK.
You are prompted to enter a name for the driver.
9. Enter an appropriate driver name (for example, 1747-SDNPT-3)
and click OK.
The new driver is added to the Configured Drivers in RSLinx
software. (Your list contains the drivers you have configured for
your system.)
10. Close or minimize RSLinx software.
Communicate with the DeviceNet Network
You can use RSNetWorx for DeviceNet software to communicate with
the DeviceNet network via the DH+ network once you have the DH+
pass-through driver configured.
Follow these steps to communicate by using the DH+ network.
To Next Page
Loading...
