24 Rockwell Automation Publication 193-QR004B-EN-P - January 2017
Chapter 2
Set the FLA
The FLA1 and FLA2 parameters are the motor's current ratings found on the motor's nameplate. These values are used
in the E300 relay thermal overload algorithm. You can adjust this parameter in the Overload Protection display and press
Apply. See Figure
8.
Figure 8 - Overload Protection Tab
While the FLA setting is the minimal adjustment to be made on this display, you can also configure the trip class and the
reset mode (manual or automatic) here.
To Next Page
Loading...
