5. Add Output power jumpers to Micro850 PLC
• 6x 6” Red 16GA Wire provided in kit
6. Move Upper Horizontal Wire Way Up for Clearance
• Remove Wire Way from Back Panel
• Mark new holes ¼” above the old holes
• Drill and Tap holes for 8-32 screws used to hold the Wire Way
• Attach Wire Way to Back Panel
7. Re-Connect wires that were removed from ML1000 PLC to Micro850 PLC
• Micro850 PLC has removable Screw Terminals for Inputs and Outputs. This feature
makes it easier to remove them from the PLC while reconnecting all of the inputs and
outputs.
8. Replace 250mA fuse (7FU) with 5A fuse provided in kit
To Previous Page
Loading...
Need help?
General
