494 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 17 Configuring Filters
Figure 118 - IP Filters Page
Creating an IP Filter
Follow these steps to create an IP filter:
1. If you are creating a new filter, make sure <NEW> (the default) is selected
in the Create/Edit Filter Name menu.
To edit an existing filter, select the filter name.
2. Enter a descriptive name for the new filter in the Filter Name field.
3. From the Default Action pull-down, select Forward all or Block all.
The filter’s default action must be the opposite of the action for at least one
of the addresses in the filter. For example, if you create a filter containing
an IP address, an IP protocol, and an IP port and you select Block as the
action for all of them, you must choose Forward All as the filter’s default
action.
To Next Page
Loading...