112 Rockwell Automation Publication 1783-UM010C-EN-P - June 2019
Chapter 9 Updating the Device
Figure 31 - Example of Command to Copy Boot Image from SD Card
4. Once the image is copied to disk0, change the pointer and tell it to boot
from that image.
Ty p e sw-module module sfr recover configure
image disk0:asasfr-5500x-boot-6.4.0-1.img.
5. Boot the new image:
You are prompted for confirmation.
6. Press Enter to confirm that you want to recover the module.
The system begins to shut down.
7. This step is optional.
If you issue a show module sfr details command, you see three
states, depending on time elapsed.
• Ready/Shutting Down indicate that this is the session/status lines
• Not ready/Recover indicates that the device is booting
To Next Page
Loading...