Allen-Bradley Stratix 5950 - Reinstall an SFR Module

120 Rockwell Automation Publication 1783-UM010C-EN-P - June 2019
Chapter 10 Troubleshoot
4. stratix5950(config)# configure terminal
5. “Would you like to enable anonymous error reporting to help improve
the product?”. Enter N
6. stratix5950(config)# enable password
<YOUR_ENABLE_PASSWORD>
7. stratix5950(config)# interface Management1/1
8. stratix5950(config-if)# ip address
<ASA_IP_ADDRESS> <ASA_NETMASK>
9. stratix5950(config)# http <ASA_IP_ADDRESS>
<ASA_NETMASK> management
10. stratix5950(config)# wr
11. copy ftp://
FTP_USERNAME:FTP_PASSWORD@FTP_IP_ADDRESS/
asasfr-5500x-boot-5.4.1-213.img disk0:
12. Press enter for all prompts.
13. stratix5950(config-if)# dir
a. Confirm that asasfr-5500x-boot-5.4.1-213.img is listed.
14. stratix5950(config-if)# sw-module module sfr
shutdown
15. Wait until SFR module status shows “Down” by running “how
module sfr”
16. stratix5950(config-if)# sw-module module sfr
uninstall
17. stratix5950(config-if)# reload
18. Wait 5 minutes until the system restarts.
Reinstall an SFR Module
Follow these steps to reinstall an SFR module from the command line.
1. stratix5950> enable
2. Set current time:
a.stratix5950# clock set 14:28:00 16 March
2016
3. stratix5950# sw-module module sfr recover
configure image disk0:asasfr-5500x-boot-
5.4.1-213.img
4. sw-module module sfr recover boot
5. Wait until SFR console is ready, by running "show module sfr
details".