16 Rockwell Automation Publication 1783-UM010C-EN-P - June 2019
Chapter 1 About the Security Appliance
Installation of the Security
Appliance
To install the Stratix 5950 Security Appliance, follow the introductions in the
Stratix 5950 Security Appliance Installation Instructions,
publication 1783-IN002
.
Express Setup Button
Express Setup resets the security appliance ASA configuration to the default
configuration set by the factory.
To restore the security appliance configuration to the default configuration set
by the factory, follow these steps.
1. Use a standard-size #1 paper clip with wire gauge 0.033 inches or smaller
and
2. Press the Express Setup button after the device is fully booted.
When depressed, the push button follows these actions.
• Depressed 0 to < 3 seconds or > 15 seconds — No action is taken.
• Depressed > 3 seconds < 15 seconds —
The appliance automatically restarts when the button is pushed. After
restart, the unit runs the original factory default configuration.
The FirePOWER module is NOT reset to Factory Default with the Express
Setup button pressed for >3 seconds and < 15 seconds.
TIP The new configuration does not take effect until after the system restarts.
The system boots with the original factory default configuration, including
ROMMON variables. The administrator can disable this feature via ASA CLI so
that no action is taken when the push button is depressed.
To Next Page
Loading...