Rockwell Automation Publication 1783-UM010C-EN-P - June 2019 49
Configure the Security Appliance Chapter 3
Configure FirePOWER Administrative Settings
To use PuTTY to connect to the serial port, follow these steps.
1. Run PuTTY and connect to the serial port of the device.
2. Click Open to start a command-line session.
3. At command line, press Enter.
4. Type: stratix5950> enable
5. Press Enter.
6. Enter the ASA password that was set in the Startup Wizard and press
Enter.
7. Type: stratix5950# session sfr console
8. Press Enter.
To Next Page
Loading...