Rockwell Automation Publication 1783-UM010C-EN-P - June 2019 65
Configure the Security Appliance Chapter 3
Change the Device from Monitor Mode to a Full Blocking
Configuration (Inline Mode Only)
The security appliance is configured from the factory in Monitor Mode
configuration. This configuration enables the appliance to show you what it
would have blocked if it was in a full blocking configuration, for test purposes.
For testing the correct functionality of the CIP DPI configuration, it is easier
to switch out of Monitor Mode into a full blocking configuration.
1. Go to ASDM>Configuration>Firewall>Service Policy Rules.
2. Edit the sfrclass rule.
To Next Page
Loading...