Publication 2092-UM001D-EN-P — July 2005
D-28 Ultra1500 Operator Interface
Pr-5.11 Reserved
Pr-5.12 Analog Output 1: Signal
Pr-5.13 Analog Output 2: Signal
Pr-5.14 Analog Output 1: Scale
Pr-5.15 Analog Output 2: Scale
Units: msec
Applicable Operating Mode: All
Ultraware Link: AC Line Loss Fault Delay
This parameter is Reserved.
Description:
The drive signal assigned to channel 1 from the Channel
Setup dialog box in the Oscilloscope window.
Range: 1 to 99999
Default: 0x00
Applicable Operating Mode:
See Monitor Variable Numbers (except 0x0F) beginning on
page D-6.
Ultraware Link: Analog Output 1: Signal
Description:
The drive signal assigned to channel 2 from the Channel
Setup dialog box in the Oscilloscope window.
Range: 1 to 99999
Default:
See Monitor Variable Numbers (except 0x0F) beginning on
page D-6.
Applicable Operating Mode: All
Ultraware Link: Analog Output 2: Signal
Description:
The amplitude of the channel 1 input signal to be displayed by
the oscilloscope.
Range: 1 to 99999
Default: 500
Units:
See Monitor Variable Numbers (except 0x0F) beginning on
page D-6.
Applicable Operating Mode: All
Ultraware Link: Analog Output 1: Scale
Description:
The amplitude of the channel 2 input signal to be displayed by
the oscilloscope.
Range: 1 to 99999
Default: 500
To Next Page
Loading...