30
5. RS340+CM301 to a dedicated Bluetooth® device such as printer.
Under this scenario, the Allflex Configurator© software is used to set the Power
Module: ON
Connection Mode: MASTER
Device Pairing: ON
Pairing Slave ID: Use the ID HEX Code for the Bluetooth® module of the printer.
Sometimes this is not written on the device. One way to find the address for the
Bluetooth® printer is to use a computer or PDA with Bluetooth® and discover the
printer and then view the Details. Once you know the address, enter it into the
“Pairing Slave ID” field. All the settings above are in the “Wireless Technologies”
Tab.
It is recommended that the TIME ON setting in the “Operational” Tab also be set to
ALWAYS ON.
It may also be necessary to adjust the data string being sent to some printers to get the
correct data onto the label. In the case of the Zebra QL320 printer shown, we set the
COMMAND PROMPT (in the “ID-Code Format” Tab) to: NO PROMPT (default
value).
To Next Page
Loading...
