Machine Grouting (North American Models Only)
1. North American models only: Raise and level the machine
off the floor on three points, using spacers such as nut fasten-
ers.
2.
Fill the space between the machine base and the floor with a
good quality non-shrinking machinery grout. Grout complete-
ly under all frame members.
3. Position washers and nuts on bolts and finger tighten nuts to
machine base.
4. Before grout sets completely, make a drain opening in the
grouting at the rear center of the machine with a stiff piece of
wire. This opening should be approximately 0.5 in. [13 mm]
wide to allow any surface water built-up under the base of the
machine to drain away. Do not omit this step.
IMPORTANT: DO NOT omit this step.
5. Allow machine grout to set, but not cure.
6. Remove the spacers carefully, allowing the machine to settle
into the grout.
7. Allow the grout to fully cure. Consult the grout manufacturer
for cure time specifications.
8. Tighten the nuts (Nuts M16; supplied with the machine) by
even increments - one after the other using the specified tor-
que - untill are tightened evenly and the machine is fastened
securely to the floor.
CAUTION
To avoid installing the machine in such a way that
may lead to the machine becoming damaged during
operation, be sure to use the washer supplied with
the machine along with an equivalent nut and bolt
with thread type M16 during installation
W945
Installation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
36 Part No. D1599ENR16
To Next Page
Loading...
