Important Safety Instructions
WARNING
Read all the instructions before using the ma-
chine. Safe these Instructions for future reference.
Electrical shock prevention
DANGER
Electrical shock hazard will result in death or serious
injury
.
Before inspecting, maintenance or servicing ma-
chines, power supply must be turned OFF
. The serv-
icer needs to wait for at least ten (10) minutes after
turning the power OFF.
This machine must be connected to a grounded met-
al, permanent wiring system, and an equipment
grounding conductor must be run with the supply
conductors and connected to the equipment ground-
ing terminal on the machine.
When the main switch is turned off, the inlet termi-
nals of the main switch are still under current.
The inverter remains charged with high voltage for
some time after powering OFF. Before starting in-
spection of the inverter, check for residual voltage
across main circuit terminals “ + “ and “ - “. This
voltage must be below 30 VDC before the servicer
can access the inverter for inspection.
Do NOT connect inverter manufacturer devices or
other devices to the frequency controller to manipu-
late the behavior. No modification to the settings are
allowed.
This is an imminently hazardous situation that, if not
avoided, will cause severe personal injury or death.
Installation – Maintenance prevention
WARNING
Machine installations must comply with minimum
specifications and requirements stated in the appli-
cable Installation Manual, any applicable municipal
building codes, water supply regulations, electrical
wiring regulations and any other relevant statutory
regulations. Due to varied requirements and applica-
ble local codes, this machine must be installed, ad-
justed, troubleshooting and serviced by qualified
maintenance technician which is familiar with the ap-
plicable local codes and the construction and opera-
tion of this type of machinery. They must also be fa-
miliar with the potential hazards involved. Failure to
observe this warning may result in personal injury
and/or property damage.
Always verify the static and dynamic requirements
with a building engineer to meet the requirements of
the permissible loads, vibrations and noise level of
the building.
Ensure and install the machine on a level floor of
sufficient strength. Ensure that the recommended
clearances for inspection and maintenance are pro-
vided. Never allow the inspection and maintenance
space to be blocked.
To reduce the risk of fire, this appliance must be in-
stalled and secured to an uncovered not obstructed
concrete floor.
If a forklift or a pallet truck is used to transport or in-
stall the machine, ensure that the carrying capacity
and the forks length are sufficient. By given center of
gravity, pay the necessary attention to the distribu-
tion of the center of gravity by lifting and transport.
In case the machine needs to be anchored, do not
tighten nuts of the anchoring bolts before the con-
crete base around the bolts is completely hardened.
The bolts must be tightened by means of torgue
wrench.
Do not install the machine over an open water stor-
age or drain system.
Adequate ventilation must be provided to avoid the
back flow of gases into the room from appliances
burning other fuels.
Safety Information
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
6 Part No. D1599ENR16
To Next Page
Loading...
