9. Press the START keypad.
10. During first 150 seconds, the desired wash cycle can be
changed. After first 150 seconds have ended, the wash cycle
active at that moment remains the chosen wash cycle.
1
1. The wash cycle time is counted down to zero on the display.
After completion, the door lock unlocks and the display
shows “UNLOAD”.
Before Washing
1. Sort the linen according on the temperature and the instruc-
tions of the manufacturer of the fabrics.
2. Check if there aren‘t any strange objects between the linen
like nails, screws, needles, etc. in order not to damage the
washer
-extractor or the linen.
3. Turn sleeves of shirts, blouses, etc. inside out. To get a better
washing result, you have to unfold the fabrics and mix the
bigger and smaller pieces of fabrics.
4. Close metallic buttons, e.g. on jeans. Open buttons can get be-
tween the drum and tub/door glass and damage it.
NOTE: Different fabrics have different densities. Loads
must be adjusted accordingly to meet machine loading
specifications. The optimal washing load is determined
by the loading ratio (kg/lb linen : l/gal drum volume).
The proper loading ratio is determined by the type of
linen and other factors. Cotton textiles normally require
a loading ratio of 1:10-1:13, which is a full drum load.
Synthetics and blended fabrics usually require a load-
ing ratio of 1:18-1:20, which is half drum load.
Power Cut
If a power cut occurs in an idle condition of the machine and no
wash program is running, the machine remains in the idle condi-
tion.
Models without numeric keypad
If a power cut occurs during the wash process and the door re-
mains closed and locked, the wash program will, after the power
supply has been restored, automatically continue in the program
beginning from the step in which the program was interrupted.
For machines fitted with an automatic door-lock unlocking mod-
ule, refer to Automatic Door
-lock Unlocking Module section. If
during the power cut, the door lock gets unlocked and the door
remains closed, the message "PRESS START / OPEN DOOR"
appears as soon as the power supply is restored. If you open the
door, the wash program will be cancelled. If you press the
START button, the wash program will continue beginning from
the step in which the program was interrupted.
Models with numeric keypad
If a power cut occurs during the wash process, the message
"CONTINUE / STOP" appears as soon as the power supply is re-
stored. If you press the STOP button, the wash program will be
cancelled. If you press the START button, the wash program will
continue beginning from the step in which the program was inter-
rupted.
Automatic Door-lock Unlocking Module
Some machines are fitted with an automatic module for unlock-
ing the door lock in case of a power cut.
If a short term power cut occurs, this module does not affect the
operation of the machine.
If a long term power cut occurs, the module unlocks the door
lock. It is then possible to open the door and remove laundry
.
Operation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
71 Part No. D1599ENR16
To Next Page
Loading...
