Default Cycle dCyC
This option allows the owner to set the default cycle type.
1. Control must be in Manual Mode. Refer to How to Enter the
Manual Mode.
2. Press the PERM PRESS/WARM (∧) or the DELICATES/
COLD (∨) keypad until PrOg appears in the Four-Digit Dis-
play.
Figure 21
3.
Press the START (enter) keypad and AtS will appear in the
Four-Digit Display.
4. Press the PERM PRESS/WARM (∧) or the DELICATES/
COLD (∨) keypad to scroll through the programmable options
until dCyC appears in the Four-Digit Display.
Figure 22
5.
When dCyC appears in the Four-Digit Display, press the
START (enter) keypad. A letter code will appear in the Four-
Digit Display. This code (found below) corresponds to the cy-
cle type.
hEAy = NORMAL/HOT
nOrL = NORMAL/WARM
PP = PERM PRESS/WARM
dEL = DELICATES/COLD
6. Press the PERM PRESS/WARM (∧) or the DELICATES/
COLD (∨) keypad to increase or decrease the current code
displayed in the Four-Digit Display to the desired code.
7. Press the START (enter) keypad when the correct code ap-
pears in the Four-Digit Display.
NOTE: To program other options, refer to the appro-
priate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option, not a val-
ue.
2. While pressing and holding the NORMAL/HOT keypad with
one hand, press the NORMAL/ WARM keypad with the other
hand. The control will revert back to the previous mode of op-
eration.
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
21 Part No. 202713ENR1
To Next Page
Loading...
