801683 115
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
• Motor not grounded! Disconnect electric power before servicing motor.
W485
WARNING
55. HEATING ELEMENT (Models Equipped
with Heater)
a. While supporting lower access panel, remove
two screws from bottom edge of panel and
remove panel. Refer to Figure 25.
b. Disconnect all wires from heating element.
c. Loosen nut and lockwasher from center
terminal of heating element. Refer to Figure 50.
d. Grasp heating element by the terminals. Pull
element and rubber washer through opening in
outer tub front panel. Refer to Figure 50.
NOTE: All rubber from old element gasket must be
removed prior to installing a new element.
NOTE: When installing new heating element
assembly, elements must be positioned in the same
spot as old elements. Refer to Figure 50.
Figure 50
Outer
Tub Front
Panel
Seal
Clamp Ring
Heating
Element
Screw
Washers
Nut
To Next Page
Loading...
