Alliance Laundry Systems HWFB61WN1102 - Page 84

82 801683
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
• Motor not grounded! Disconnect electric power before servicing motor.
W485
WARNING
Rear Control Washers
a. While supporting lower access panel, remove
two screws from bottom edge of panel and
remove panel. Refer to Figure 25.
b. Using the special tool, No. 318P4, remove
dispenser drawer. Refer to Figure 26.
c. Open loading door. Carefully remove wire
clamp ring from groove with small flat blade
screwdriver. Spring is in 6 o’clock position.
Refer to Figure 27.
NOTE: To avoid damage to spring, use screwdriver
on wire clamp ring to right or left of spring.
d. Grasp loading door seal lip. Refer to Figure 46,
Step “1”.
NOTE: To avoid damage to door seal, DO NOT use
pliers or sharp objects to grasp the door seal lip. If
lip is damaged, seal will leak.
e. Using a circular motion, pull seal up
(Figure 46, Step “1”), out (Figure 46, Step
“2”), and down (Figure 46, Step “3”).
f. When seal releases from lip of front panel, pull
out and remove the seal from front panel around
door opening. Refer to Figure 46, Step “4”.
g. Remove bottom two front panel attaching
screws. Refer to Figure 29.
h. Remove front panel (with loading door
attached) away from washer as far as wires
permit.
i. Unplug wire harness from both the door latch
switch and from the door switch. Refer to
Figure 29. Remove clips holding wire harness
and door seal hose along top flange of front
panel and remove front panel.
Figure 25
H202SE1A
Screws
Lower
Access Panel
Panel
Locators
Figure 26
B
L
E
A
C
H
S
O
F
T
E
N
E
R
M
A
X
M
A
X
B
L
E
A
C
H
S
O
F
T
E
N
E
R
M
A
X
M
A
X
H125SE3B
Remove Drawer
From Housing
318P4
Dispenser Drawer
Tool
Insert
Tool
Pull Drawer Out
Slightly