Alliance Laundry Systems SFNNYRSP116TW01 - 45 Degree Front Control Models

1
FLW31R_SVG
FLW32R_SVG
1
W521I_SVG
1
FLW6R_SVG1
2
1. Service Door
2. Control Panel
Figure 3
45 Degree Front Control Models
Manual programming requires the user to remove the cabinet top
or control panel and unplug the bullet connector located between
the “white/black” and “red/blue” wires. This will allow the user
to access various programming options, diagnostics, and audit ca-
pabilities. Refer to Figure 4 .
1. Remove the screws from the back of the top panel that attach
the top panel to the machine.
2. From the back of the machine, using a screwdriver, pry the
top panel upward and towards you.
3. Remove the screws from the top of the control panel that at-
tach the control panel to the machine.
4. Remove the screws from the bottom of the control panel that
attach the control panel to the machine.
FLW2384N_SVG
Figure 4
Opening the Service Door
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
22 Part No. 807870ENR3