This option allows the owner to set the vend price for all cycles,
but otherwise specifically for NORMAL HOT. This price should
be set before all other prices. This vend price will be shown in the
display when NORMAL HOT is selected.
1. Control must be in Manual Mode. Refer to How to Enter the
Manual Mode.
2.
Press the DELICATE (∧) or the HOT (∨) keypad until Prog
appears in the display. Press the START (enter) keypad, and
AtS 1 will appear in the display.
3. Press the START (enter) keypad. All cycle LEDs will be lit to
show all cycle prices are being programmed.
NOTE: To go back to the current programmable op-
tion without changing the value, press the WARM (<)
keypad.
4. Press the DELICATE (∧) or the HOT (∨) keypad to increase
or decrease the value of the active digit and the START (en-
ter) keypad to enter the value of the digit and advance to the
next digit.
5. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
45 Part No. 807870ENR3
To Next Page
Loading...
