Signal Value Start Mode
Serial or Net-
work Vending
Command
Signal
Coin/Card In-
put End of Cycle Key Pressed
24 ON ON OFF OFF OFF
25 ON ON OFF OFF ON
26 ON ON OFF ON OFF
27 ON ON OFF ON ON
28 ON ON ON OFF OFF
29* ON ON ON OFF ON
30 ON ON ON ON OFF
31 ON ON ON ON ON
* Factory default setting.
Table 5
Network Node Number nodE
This option allows the owner to program a unique number used
for wired or wireless communication. Every machine on the same
network much have a different node number to work correctly.
1. Control must be in Manual Mode. Refer to How to Enter the
Manual Mode.
2.
Press the DELICATE (∧) or the HOT (∨) keypad until Prog
appears in the display. Press the START (enter) keypad, and
AtS 1 will appear in the display.
3. Press the DELICATE (∧) or the HOT (∨) keypad to scroll
through the programmable options until nodE appears in the
display.
4.
When nodE appears in the display, press the START (enter)
keypad. The current Network Node Number status will appear
in the display.
5. Press the DELICATE (∧) or the HOT (∨) keypad to change
the current status.
6. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Error Code Programming Error-
This option allows the owner to turn on or turn off certain errors
in the control.
1. Control must be in Manual Mode. Refer to How to Enter the
Manual Mode.
2.
Press the DELICATE (∧) or the HOT (∨) keypad until Prog
appears in the display. Press the START (enter) keypad, and
AtS 1 will appear in the display.
3. Press the DELICATE (∧) or the HOT (∨) keypad to scroll
through the programmable options until Error- appears in
the display.
4.
When Error- appears in the display, press the START (en-
ter) keypad. There are multiple programmable error code pa-
rameters. Refer to Table 6 .
5. Press the DELICATE (∧) or the HOT (∨) keypad to select the
desired option.
6. Press the DELICATE (∧) or the HOT (∨) keypad to select er-
ror code.
7. Press the START (enter) keypad when the correct code ap-
pears in the display. The current status will appear in the dis-
play.
NOTE: Press the DELICATE (∧) or the HOT (∨) key-
pad and then the START (enter) keypad again to
choose a specific coin error parameter. Refer to Ta-
ble 6 .
8. Press the DELICATE (∧ ) or the HOT (∨) keypad to change
the status.
9. Press the START (enter) keypad when the correct status ap-
pears in the display. The next Error Code Programming op-
tion will appear in the display.
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
54 Part No. 807870ENR3
To Next Page
Loading...
