14 70143101
Section 3 Troubleshooting
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
11. BURNERS NOT BURNING PROPERLY
12. CYLINDER DOOR OPENS DURING OPERATION
NOTE: All tumble dryer panels must be in place and on the machine for proper operation.
POSSIBLE CAUSE TO CORRECT
Dirt in burners. • Disassemble burners and blow out the dirt.
Gas pressure too high or low. • Check rating plate on back of tumble dryer for correct gas
pressure.
Incorrect orifices. • Tumble dryer is equipped for the type of gas specified on
rating plate. If orifices are different from that specified on
rating plate, obtain and install correct orifices.
Restricted or blocked exhaust duct. • Disassemble and clean exhaust system.
Airflow switch not functioning properly. • Replace airflow switch.
Inadequate make-up air. • Refer to Installation Instructions (supplied with tumble
dryer) for make-up air requirements.
POSSIBLE CAUSE TO CORRECT
Tumble dryer improperly leveled. • Refer to SECTION 6 in this manual for leveling leg
adjustment.
Excessive load in tumble dryer. • Remove part of load and restart tumble dryer.
To Next Page
Loading...