Alliance Laundry Systems ST0300DRG - Section 5 Service Procedures

70143101 17
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Section 5
Service Procedures
IMPORTANT: When reference is made to the left
or right hand direction in this manual, it is from the
service person’s position facing the front of the
tumble dryer.
13. LOADING DOOR ASSEMBLY
Refer to Figure 1.
a. Open loading door.
b. While supporting door, remove two screws
from hinge cam at top of door and slide door out
of the bottom hinge.
c. Remove door.
14. DOOR HINGE
Refer to Figures 1 and 2.
a. Open loading door.
b. While supporting door, remove two screws
from hinge cam at top of door and slide door out
of the bottom hinge.
c. Remove door.
d. Remove nuts and screws holding hinge to door
frame. Refer to Figure 2.
15. DOOR HANDLE
Refer to Figure 2.
a. Open loading door.
b. Remove screws holding door handle to door.
Figure 1
T252SE1B
DOOR
HINGE LUG
HINGE CAM
SCREW
Figure 2
T301SE1B
DOOR
HANDLE
DOOR
HANDLE
SCREW
DOOR
FRAME
NUT
HINGE
DOOR
FRAM
E
SCRE
W