20 70143101
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
17. DOOR SWITCH (ALL MODELS)
Refer to Figure 5.
a. Remove two screws from loading door hinge
lug. Refer to Figure 1.
b. Remove screws from bottom of front panel.
Refer to Figure 4.
STACKED TUMBLE DRYERS ONLY:
Remove lint drawer and screws. Refer to
Paragraph 16.
a. Loosen screws at top of front panel.
b. Tilt front panel out and away from tumble
dryer.
c. Disconnect wires to door switch.
NOTE: Refer to wiring diagram when rewiring
door switch.
d. Press switch tabs in and push switch out
through front panel.
To reduce the risk of serious injury the door
switch MUST be reinstalled after service is
complete.
W241
WARNING
Figure 5
T258SE1A
DOOR
SWITCH
SWITCH
TABS
To Next Page
Loading...