Alliance Laundry Systems ST0300DRG - Lint Panel;Drawer; Lint Screen; Lint Drawer Seal

70143101 23
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
19. LINT PANEL/DRAWER
STACKED TUMBLE DRYER
Unlock drawer and pull out. Refer to Figure 9.
STAND ALONE TUMBLE DRYER
Coin
Unlock panel and remove. Refer to Figure 8.
OPL
Pull panel down from top. Refer to Figure 8.
20. LINT SCREEN
Refer to Figure 9.
STACKED TUMBLE DRYER
a. Unlock and remove lint drawer.
b. Remove lint screen.
STAND ALONE TUMBLE DRYER
a. Unlock and remove lint panel. Refer to
Figure 8.
b. Apply pressure on top of screen to release
screen from clip.
c. Remove screen.
TO REPLACE SCREEN
a. Drop bottom of screen between lugs on bottom.
Refer to Figure 9.
b. Secure top of screen behind clip.
21. LINT DRAWER SEAL
Refer to Figure 10.
STACKED TUMBLE DRYER
a. Unlock and remove lint drawer.
b. Remove damaged or worn seal from front
panel.
c. Degrease area where new seal is to be placed.
d. When installing new seal, make sure it does not
extend into lint drawer opening cavity.
Figure 9
T260SE1C
STAND ALONE TUMBLER
STACKED TUMBLER
LINT
SCREEN
LINT
SCREEN
LINT
DRAWER
LOCK
CLIP
LUG
For personal safety use degreaser/solvent
only in a well ventilated area away from any
open flames or sources of ignition.
W242
WARNING