30 70143101
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
29. CYLINDER SEALS
Refer to Figure 20.
REAR CYLINDER SEAL
a. Remove cylinder assembly. Refer to
Paragraph 27.
b. Remove seal from seal support on rear panel.
c. Degrease area where new seal is to be placed.
Scrape any remaining seal/glue remnants from
seal support.
d. Apply generous amount of glue into seal
support.
e. Carefully install seal into glue surface. Apply
pressure until glue is able to support seal and
hold it in position.
FRONT BAFFLE GASKETS
Refer to Figure 21.
a. Remove lint panel/drawer. Refer to
Paragraph 19.
b. Remove control panel and controls. Refer to
Paragraph 18.
c. Remove front panel. Refer to Paragraph 16.
d. Remove gasket from baffles.
For personal safety use degreaser/solvent
only in a well ventilated area away from any
open flames or sources of ignition.
W242
WARNING
Figure 20
TMB1754S
CENTER
CYLINDER
SEAL
REAR
CYLINDER
SEAL
TRUNNION
ASSEMBLY
FELT
SEAL
CYLINDER
ASSEMBLY
BEARING
WASHER
PALNUT
JAM NUT
SUPPORT
SCREWS
CYLINDER
GUIDE TOOL
SEAL
SUPPORT
To Next Page
Loading...