Alliance Laundry Systems ST0300DRG - Roller Support and Baffle Assembly

70143101 31
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
30. ROLLER SUPPORT AND BAFFLE
ASSEMBLY
Refer to Figure 21.
a. Remove cylinder and bearing assembly. Refer
to Paragraph 27.
b. Remove cylinder seals. Refer to Paragraph 29.
c. Remove screws holding roller support to
cabinet.
d. Remove screws holding baffles to heat shields.
e. Remove screws holding baffles to center
partition.
f. Remove baffles.
Figure 21
T410PE3B
BAFFLE
GASKET
GASKET
GASKET
ROLLER
SUPPORT
CENTER
PARTITION
HEAT SHIELDS
BAFFLE